Weird left crank creak
tomsimmonds
Posts: 66
hi,
For some reason my left shimano crank arm starts to make a creaking/ticking noise when pressure is applied. When i take the two bolts out greece them and put back in it has gone. However after a ride or after being left for a day or two the creak seems to come back until i take the bolts out and re-apply. Does anyone have an idea as to what this could be ?
thanks
Tom
For some reason my left shimano crank arm starts to make a creaking/ticking noise when pressure is applied. When i take the two bolts out greece them and put back in it has gone. However after a ride or after being left for a day or two the creak seems to come back until i take the bolts out and re-apply. Does anyone have an idea as to what this could be ?
thanks
Tom
0
Comments
-
Is this a Hollowtech 2 setup? I'd suggest it's more likely to be the BB cup moving in the frame. Try greasing (or anti-seizing) and re-tightening both cups.0
-
Also, check your pedals.0
-
-
If you're taking out the pinch bolts you should take the opportunity to check the bearing preload by loosening and re-tightening the plastic end cap. Finger tight only, using the correct little plastic tool.
Or better still, remove the preload cap and crank completely, clean and regrease the mating surfaces / splines on both axle and crank arm, and reinstall it. Preload the bearings by tightening the end cap, then insert the pinch bolts together with the plastic retaining tab which fits in the gap. Progressively tighten the pinch bolts alternately until tight.0