On one Scandal 26er

Thought I'd put some pics up of this mornings build.
I've come from a long line of old school bikes and found nothing to compare to the trusty 1999 Zaskar LE that I recently retired due to ill health
The first replacement for it was a Ragley Piglet frameset that I eventually found a sweet spot in the set up, but it was never any where near as light or as fast and planted going uphill as the Zaskar was.
So, after mucho deliberating and searching, I have settled on a Scandal. The Geometry when used with a 80mm stem and 100mm forks gives me within a mm of the Zaskar and the same angles.
I went with a 20" frame as although my legs are short, I have a long torso and arms so like a long top tube.
All in all so far so good and I can't wait to finish it off.
The components are a bit mix and match and I am debating going 1 or 2 x 10, but for the moment the 8sp seems to work well.
The chain and gear cables need replacing and a seat post / collar are to go on. What is there is for an indicative picture only and the saddle will go up some.
A box of bits.

A new frame

Some forks

And some time later

A little bit of work still to do, and I am unsure about the green race face bars.
I think a nice set of wide carbon risers are in order, but will see how it rides first.
Future upgrades may be wheels and brakes, but for now both are functional and as it is essentially a second bike to my FS, I probably shouldn't spend too much more.
Thought and comments appreciated.
Frame: On One scandal 26er 20"
Forks: 2006 Reba team Air U-turn
Bars: Race Face XC 720mm wide
Stem: Exotic 80mm 31.8
Headset: FSA Orbit 2
Grips: Race Face
Brakes: Shimano LX disks. 180mm front, 160mm rear
Shifters: LX 8sp
Cables: Shimano
Front Mech: Deore 9sp
Rear Mech: XTR shadow
Seat: WTB Shadow
Seat Post: None yet
Seat Post Clamp: None yet
Cranks: SLX
Chainring(s): SLX
Chain: None yet
Cassette: Old XT 8sp
Pedals: M520 spd
Bottom Bracket: SLX
Front Wheel:
Rim: DT 4.2D
Spokes: double butted
Hub: Shimano LX
Tube: rubber
Tire: Rocket Ron
Back Wheel:
Rim: DT 4.2D
Spokes: double butted
Hub: Shimano LX
Tube: rubber
Tire: Rocket Ron
Weight: 11KG as the pics.
I've come from a long line of old school bikes and found nothing to compare to the trusty 1999 Zaskar LE that I recently retired due to ill health

The first replacement for it was a Ragley Piglet frameset that I eventually found a sweet spot in the set up, but it was never any where near as light or as fast and planted going uphill as the Zaskar was.
So, after mucho deliberating and searching, I have settled on a Scandal. The Geometry when used with a 80mm stem and 100mm forks gives me within a mm of the Zaskar and the same angles.
I went with a 20" frame as although my legs are short, I have a long torso and arms so like a long top tube.
All in all so far so good and I can't wait to finish it off.
The components are a bit mix and match and I am debating going 1 or 2 x 10, but for the moment the 8sp seems to work well.
The chain and gear cables need replacing and a seat post / collar are to go on. What is there is for an indicative picture only and the saddle will go up some.
A box of bits.

A new frame

Some forks

And some time later

A little bit of work still to do, and I am unsure about the green race face bars.
I think a nice set of wide carbon risers are in order, but will see how it rides first.
Future upgrades may be wheels and brakes, but for now both are functional and as it is essentially a second bike to my FS, I probably shouldn't spend too much more.
Thought and comments appreciated.

Frame: On One scandal 26er 20"
Forks: 2006 Reba team Air U-turn
Bars: Race Face XC 720mm wide
Stem: Exotic 80mm 31.8
Headset: FSA Orbit 2
Grips: Race Face
Brakes: Shimano LX disks. 180mm front, 160mm rear
Shifters: LX 8sp
Cables: Shimano
Front Mech: Deore 9sp
Rear Mech: XTR shadow
Seat: WTB Shadow
Seat Post: None yet
Seat Post Clamp: None yet
Cranks: SLX
Chainring(s): SLX
Chain: None yet
Cassette: Old XT 8sp
Pedals: M520 spd
Bottom Bracket: SLX
Front Wheel:
Rim: DT 4.2D
Spokes: double butted
Hub: Shimano LX
Tube: rubber
Tire: Rocket Ron
Back Wheel:
Rim: DT 4.2D
Spokes: double butted
Hub: Shimano LX
Tube: rubber
Tire: Rocket Ron
Weight: 11KG as the pics.
0
Posts
I have to say that I was quite surprised at how light it felt when I picked it up.
I found £30 in my Paypal so have bought some green spangly bits to break it up a bit.
The next picture will be it built up properly with green seat post clamp, crank bolts and cable ends
I'm hoping it will ride well and can't wait to try on the trails.
I very nearly went down the steel framed 150mm hardtail with slack geometry, but after deciding that the Piglet was too far away from my ideal I think that would have been a mistake.
Quite hard to picture it properly, but it has green chainring bolts, cable ends and seatpost clamp.
Had the first ride today around a wet and very soggy local woods.
Have to say it rides very well indeed.
On paper and to a degree by the photo it looks like the frame is too large.
I knew this would be the case as I have relatively short legs - but I wanted a stretched frame without the seat being 14 miles above the bars. For me this works well and tbh I care not what it looks like
Seem to be almost effortless along singletrack and whilst the conditions didn't lend themselves to flying around every where, I never felt like the bike was holding me back.
Downhill it feels quite strange. Sort of glides over things rather like the Piglet frame it replaced - not at all harsh and girder like of my previous Zaskar. Uphill it is more Zaskar than Piglet, which is 100% what I wanted.
Very impressed and need it to dry up a tad for a longer faster ride.
My Scandal weight weenie project is on hold as my car is falling apart and needs replacing yesterday. Get that out of the way and a tough sensible but lightweight rocket will hopefully appear when the trails are dry and dusty and the sun is shining.
Enjoy your ride!
I just could never have an on-one with those funny yoked seatstays - just don't like the look of them!
retired 9.6kg Carrera Kraken
The Carrera Hardtail combined thread - come on all you Carrera's!
The Sons Scott Genius RC20 build
I'm much of the same opinion about the seat stays, but for the money there was no real option - other than second hand (which I didn't want to do)
It was this or a Merlin / Rock Lobster frame. The Merlin Malt 3 very nearly bought but I was slightly put off by the very short top tube, especially when part of the spec was for a long TT with shorter stem.
I'm sure I'd have been happy with a rock lobster in the end, but I'm very happy with the Scandal so far.
A ride on the FS over the weekend will probably dampen my love for the hardtail
The forks will soon be replaced with white Maguras and I fancy some carbon risers, so the green will be going.
Shall post more pics when it's done around February time.
Mods are Magura MD100R 100mm forks.
Superstar switch evo - stans crest rims
Formula K24 brakes
Easton EC70 carbon bars
The green has gone
First ride as is now will be tomorrow.
The 'new' forks and brakes were hand me downs from my recently upgraded FS.
The wheels were brand new and during the first ride after a massive 4.5 Miles of Sherwood Pines, the back one kindly released itself of tension in every single spoke this afternoon.
A push to the car park left me rather unhappy and they are heading back to SS tomorrow .... grrrr
The Scandal frame has gone, the wheels and forks are now on my OH's bike, and the rest is in a box in the garage.
This weekend I will be building up a C456 with 140mm Revelation 426 forks and a few other bits and pieces
This will be my final attempt to get a hard tail that I actually want to ride instead of my FS.
If it doesn't create the desire then I'll go back to n (with no +1)
edit...