XT 756 rear hub axle movement

Richie63
Richie63 Posts: 2,132
edited January 2010 in MTB workshop & tech
Problem... found movement in the axle of the rear hub
purchased spanners and tightened up lock nuts
BUT....
found that spanner (parktool one 17mm ) is caught between locknut and cassette so can't tighten up enough and so still have play
So is the specific one from shimano thinner so to allow propper tightening or am I missing something?
I'm going to blow the bank on a new build ( within reason ) NOW DONE!!
http://i570.photobucket.com/albums/ss14 ... 010362.jpg

Comments

  • nicklouse
    nicklouse Posts: 50,675
    remove the cassette.

    but it is easier to strip the hub down and tighten the cassette side cone and lock nut up fully then rebuild the hub and set the disc side last.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • Richie63
    Richie63 Posts: 2,132
    Cheers
    Thought I could get away with out having to do that. A trip round to my mates house to get the cassette tool then...
    I'm going to blow the bank on a new build ( within reason ) NOW DONE!!
    http://i570.photobucket.com/albums/ss14 ... 010362.jpg

Categories