Forum home› Mountain biking forum› MTB workshop & tech

removing 9mm adapter from Switch Evo hub

felix.londonfelix.london Posts: 4,067
edited November 2013 in MTB workshop & tech
Am I just being stupid? I can see how to do this...
"Why have that extra tooth if you're not using it?" - Brian Lopes

Votec V.SX Enduro 'Alpine Thug' 2012/2013 build

Trek Session 8

Posts

  • stubsstubs Posts: 5,001
    iirc you need to pull the end caps off they are held in place by O rings. I remmber them being a bloody tight fit and ended up wrapping one cap in a rag clamping it into a workmate bench and pulling and twisting as hard as I could on the wheel and nearly ending up on my backside when it came out.
    Fig rolls: proof that god loves cyclists and that she wants us to do another lap
  • felix.londonfelix.london Posts: 4,067
    yeah, that's pretty much spot on. Managed to get it off eventually.

    Cheers.
    "Why have that extra tooth if you're not using it?" - Brian Lopes

    Votec V.SX Enduro 'Alpine Thug' 2012/2013 build

    Trek Session 8
  • stubsstubs Posts: 5,001
    I made sure to put a spot of Teflon grease on the O rings when I reassembled so they didnt glue themselves in again and hopefully keep water out
    Fig rolls: proof that god loves cyclists and that she wants us to do another lap
Sign In or Register to comment.