Quarq + Edge 500 calibration?

Tom Dean
Tom Dean Posts: 1,723
edited October 2013 in Training, fitness and health
It is supposed to take a few rides for the offset figures to settle, so don't read too much into it for now.

Comments

  • SBezza
    SBezza Posts: 2,173
    With the torque value, if you stopped pedalling and then waited about 10 secs before going into the calibration screen, it would show 0. I think it takes a few seconds of no power applied in the calibration screen for it to show 0, it doesn't affect power readings however, or the zero offset.

    I always zero offset my Quarq at the beginning of a ride and then about 20 mins in, it is always stable after that. In that 20 mins mine can move around 15-20 points, but always seems to rock solid after that. It will move with different temps as well, so if you started off with it cold and then was out when it got warmer, it might be a good idea to occasionally do an auto zero offset by back pedalling 4 or 5 revs.
  • mattclinton
    mattclinton Posts: 57
    Sounds like it's working just fine!
    @MattyClinton

Categories