Easy way to adjust brake position?

simey83

Hello There,

There is a bit of rubbing on my rear brake (its a Tektro Auriga Comp custom with 160mm rotor). When i look at it i see the brake disk is ever so slightly over to the right. So there is a gap a the left but pretty much none on the right side. The disk seems to be straight. Is there an easy way to center the caliper? There are a number of screws on it but i dont know which would, if any, do the trick.

Thanks

The Northern Monkey

point 5!

http://www.bikeradar.com/gear/article/w ... ing-22829/

simey83

Thanks mate.

I noticed the disc rubs slightly at one point when it re-calibrate the pads. This means the disc is slightly bent at one point. Do you recommend bending the disc like it says in the article?

Thanks

Greer_

You can bend it but you may make it worse. If its barely noticeable I'd leave it.

simey83

Thanks a lot guys!!!

I found the bend and gave it a slight bend back into place. It does not rub any more

Thanks again!

lpretro1

BRAKE man not BREAK! :roll:

simey83

F**k i'm a D**k :P