Easy way to adjust brake position?
simey83
Posts: 113
Hello There,
There is a bit of rubbing on my rear brake (its a Tektro Auriga Comp custom with 160mm rotor). When i look at it i see the brake disk is ever so slightly over to the right. So there is a gap a the left but pretty much none on the right side. The disk seems to be straight. Is there an easy way to center the caliper? There are a number of screws on it but i dont know which would, if any, do the trick.
Thanks
There is a bit of rubbing on my rear brake (its a Tektro Auriga Comp custom with 160mm rotor). When i look at it i see the brake disk is ever so slightly over to the right. So there is a gap a the left but pretty much none on the right side. The disk seems to be straight. Is there an easy way to center the caliper? There are a number of screws on it but i dont know which would, if any, do the trick.
Thanks
0
Comments
-
-
Thanks mate.
I noticed the disc rubs slightly at one point when it re-calibrate the pads. This means the disc is slightly bent at one point. Do you recommend bending the disc like it says in the article?
Thanks0 -
You can bend it but you may make it worse. If its barely noticeable I'd leave it.0
-
Thanks a lot guys!!!
I found the bend and gave it a slight bend back into place. It does not rub any more
Thanks again!0 -
BRAKE man not BREAK! :roll:0
-
