Converted to disc brakes

zippy12
zippy12 Posts: 20
edited September 2009 in MTB beginners
Hi,
I'm currently upgrading from avid speed dial 5 V-brakes, to avid juicy 3's. My question is what do you do with the old v-brake mounting holes on the frame and the forks?
Do I just leave them as is or is there something to tidy them up a bit?
Cheers in advance

Comments

  • CraigXXL
    CraigXXL Posts: 1,852
    You can buy plugs/caps for them or jsut leave them if they don't bother you.
    GT Force 1.0

    Evil Sovereign
  • zippy12
    zippy12 Posts: 20
    Cheers Craig,
    Any links to where I can get them or should any good lbs stock them?
  • missmarple
    missmarple Posts: 1,980
    This should help. http://www.chainreactioncycles.com/Cate ... goryID=189 :)
  • dan shard
    dan shard Posts: 722
    Did you use a conversion kit? I was thinking of doing the same with my GT. The back frame doesn't have holes for disk brakes, so will have to use a conversion kit. The problem is, the small kits fit to the two small holes on the back bracket, but mine doesn't have those ether so looks like I will need the one with the bar that attaches to the v brake bracket.

    There is two small holes on the inside of the back frame(3mm ish) but not sure if it is meant to be used for disc breaks.

    I suppose it would help if I had pics really!!
  • zippy12
    zippy12 Posts: 20
    Did you use a conversion kit?

    No lucky for me my frame has disc mount on it.

Categories