08 xt chainset

timberjack
timberjack Posts: 279
edited March 2008 in MTB workshop & tech
I have replaced my truativ stylo chainset with a xt 770 hollowtech chainset and i followed the instructions and put a 2.5mm spacer on the drive side bottom bracket cup, then i put the crank in and it didn't line up with the front mech and the splines weren't through far enough to put the none drive crank arm on, so i took the spacer out and it all seems perfect[ i cannot test it properly as i am waiting for new wheels] i have looked on the park website and it says fit the spacer but this is for the 07 version, maybe the 08 version is different, so do i need the spacer in and do i have to adjust my front mech to suit, please help
Bianchi Via Nirone 7 Alu/Carbon, 2011
Specialized Stumpjumper, 07
Genisis Altitude 30, 09
Giant XTC4, 04

Comments

  • nicklouse
    nicklouse Posts: 50,673
    what bike? what is the bb width? how may teeth did the old big ring have and the new one?

    And yes you will normally need to reset the mech.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • timberjack
    timberjack Posts: 279
    thanks for your help but i went back into the shed and tapped the crank and hey presto it moved enough to tell me i needed to fit the spacer, all sorted now cheers
    Bianchi Via Nirone 7 Alu/Carbon, 2011
    Specialized Stumpjumper, 07
    Genisis Altitude 30, 09
    Giant XTC4, 04

Categories