Electrical cabling & Spray foam insulation?
![mr_eddy](https://forum.bikeradar.com/applications/dashboard/design/images/defaulticon.png)
mr_eddy
Posts: 830
I have a extension cable that goes through a partition wall via some of that cable trunking, Its not a perfect job but for what is needed its fine and looks quite neat.
Since then we have done some insulation work and the foam is now covering about 8" of the cable where it goes through the wall. The full cable is 3M long
My question is given that a small section of cable is fully covered with spray foam (8") is that going to cause a fire hazard?
A few points to note:
* The extension cable is 13A and was brand new from Curry's so meets all safety standard
* The extension cable is fully wound out i.e. its fully extended along skirting board trunking not coiled up anywhere
* The extension cable is powering the following on the other side of the wall - 1 x laptop charger (65w) and 1 x wall mounted fan heater (1500w on max usually only on low at 800w)
So if everything is on full then I am using 1565w total.
Is this safe?
Since then we have done some insulation work and the foam is now covering about 8" of the cable where it goes through the wall. The full cable is 3M long
My question is given that a small section of cable is fully covered with spray foam (8") is that going to cause a fire hazard?
A few points to note:
* The extension cable is 13A and was brand new from Curry's so meets all safety standard
* The extension cable is fully wound out i.e. its fully extended along skirting board trunking not coiled up anywhere
* The extension cable is powering the following on the other side of the wall - 1 x laptop charger (65w) and 1 x wall mounted fan heater (1500w on max usually only on low at 800w)
So if everything is on full then I am using 1565w total.
Is this safe?
0
Comments
-
You sound like a German dentist !mr_eddy said:
Is this safe?
if the foam caught fire what would the consequences be? Would it just burn out and blacken everything?
Your cable is carrying about 7 amps, I can't see it even getting warm so there is no reason for it to suddenly burst into flames.
Electrical fires are often down to poor contacts in sockets or shorts etc causing local heating. Is the cable protected by a circuit breaker? In that case a short should not be possible.
So I would say the risk is acceptable.
BASI Nordic Ski Instructor
Instagramme0 -
i would say the risk is less than negligible.0
-
Minimal risk, if the cables rated for that level of juice the cores will be a 1.5mm or something so you wont even feel the cables getting warm.
You can slap an RCD on the end going into the wall as David said unless the extension lead has a build in one.0 -
Some foam, especially if it contains Polystyrene can leach the plasticisers out of the insulation covering of the cable, causing it to perish. Can you not remove the cable, drill a 25mm hole and line it with a length of 22mm overflow pipe and then thread the cable back through that? That's what I would do.
"If" for any reason there was a house fire even if not directly related to the condition you describe then an insurance company might raise doubts over the electrical safety.Sometimes. Maybe. Possibly.
0 -
Thanks for replies, sounds like I am all good then. Will fret no more!0
-
bit of a bodge mind.0