Bottom Bracket Alignment

quarkrad809

I have a press fit kit and installed a bb successfully - but had a job aligning the plastic shell. Most videos I've watched seem to just assume everything is lined up ok so that when the press kit is used the plastic inner shell meets 100% with the two bearing fittings. Is there a technique or something else (plastic sleeve) that is used to ensure that when tightening the two shells together the inner plastic sleeve is fully aligned/mated?

feelgoodlost

Which BB are you using?

trevor.hall12

If the BB sleeve is in properly it should just go in ,and only do 2 side at a time

Unless thecBB shell is out of line