Removal of freehub body

stuf99dmeF6hNs
stuf99dmeF6hNs Posts: 4
in Workshop
Hi
So I got a pair of Rigina dp18 and the freewheel is stuck. I can't figure out which tool to use to replace it, any ideas?
Normally I'm told to use a 11 mm hex, but hole is cirkular. Maybe a giant starnut of sorts or a 2-pin not....?






Comments

  • Ben6899
    Ben6899 Posts: 9,686
    I think that should just pull off now that the axle and end caps are removed.

    It's had a hard life, eh.
    Ben

    Bikes: Donhou DSS4 Custom | Condor Italia RC | Gios Megalite | Dolan Preffisio | Giant Bowery '76
    Instagram: https://www.instagram.com/ben_h_ppcc/
    Flickr: https://www.flickr.com/photos/143173475@N05/
  • masjer
    masjer Posts: 2,809
    Although it's star shaped a hex key (allen key) should still fit.
  • stuf99dmeF6hNs
    stuf99dmeF6hNs Posts: 4
    Thx for the replace. Yes it has seen some road as it has rolled sine `96 and had 20k in all weather :) Tried pulling but it will not move. It also seems like a big hex key to be used(17 mm) if that the way...
  • mully79
    mully79 Posts: 904
    They can be weird sizes.
    The square end of a 3/8" extension bar for a ratchet fits my freehub on both my bikes.

  • stuf99dmeF6hNs
    stuf99dmeF6hNs Posts: 4

    Got hold of this badboy in the 17mm version and it actually fitted, but I couldn't get enough leverage on it without it slipping.

Categories