Thru Axle Hub Diameter

quarkrad809
quarkrad809 Posts: 43
in Workshop
I have an unbranded hub that I think maybe DT Swiss. I'm not sure if certain measurements are standard but can anybody tell me what the diameter is an a DT Swiss hub as per the attached picture please. (I have lost the end cap - the cap is 28mm dia)

Comments

  • pilot_pete
    pilot_pete Posts: 2,120
    Wouldn’t it be easier to just measure it?
  • photonic69
    photonic69 Posts: 2,965


    27.88 by my measurements


    Sometimes. Maybe. Possibly.

  • quarkrad809
    quarkrad809 Posts: 43
    photonic69 - thank you, exactly what I'm looking for. What hub make/model did this come off? This looks to be a quick release end cap - I need a thru axle end cap. It could be the case that there is a (front wheel) version of a thru axle end cap for your hub. hopefully I'm getting close to being able buy what I need. Many thanks again.
  • mully79
    mully79 Posts: 904
    Unless you have information to suggest it is DT Swiss , ratchet type, serial number etc I’d assume it’s not. The outside diameter of the end cap is going to be slightly under a standard bearings outside diameter by definition of what it is so that could also be a red herring.

    Favourite for unbranded hubs are always formula hubs, see link
    https://www.formulahubs.com/product.php?t=3
  • quarkrad809
    quarkrad809 Posts: 43
    Thank you - I have messaged formularhubs.

Categories