campag freehub bearings

chatlow

Hi all,

Been servicing my Campag Zonda rear wheel. Found that one of the bearings in the freehub needs replacing. Removing looks easy enough, but press fitting the new ones looks trickier.

I have a bottom bracket press tool, but think the diameter is too large.. any hints or tips to try and do this with non specialist tools or would I have to get a freehub press?

Thanks

Ben6899

Use the old bearing as the drift?

paul_the_pedaller

I used a suitably sized socket and a pump clamp to do my Fulcrums which are probably very similar, hardest part was getting the circlip on the lower one out.