rear mech internal cable routing problem.

thebigman
thebigman Posts: 58
edited June 2020 in Workshop
hi folks. im building a frame up and the rear mech cable exits the rear of the chainstay. There is a sleeve for the cable to go through but there is nothing stopping the outer cable from dissapearing into the frame or to butt up against.. am i missing something??


https://flic.kr/p/2jfa7w3

Comments

  • 50x11
    50x11 Posts: 408
    Yes. I would guess it's a small rubber stopper that fits into the frame and the cable outter goes into. That is what it is on all my internal routed frames.

    The frame manufacturer will likely sell a replacement.
  • whyamihere
    whyamihere Posts: 7,717
    I have a frame where the outer cable feeds into the chainstay up to about half way along, which confused the hell out of me when I was first building it... Try feeding an outer cable into the chainstay and see if it stops somewhere.
  • alwaystimetotorque
    alwaystimetotorque Posts: 226
    As above or is the frame designed so a full outer can be used from the entry point on the down tube all the way to the rear mech?

Categories