Wilier Cento Uno SR Crankset replacement?

josehernandez

Can anyone offer advice on changing the Crankset on my Wilier Cento Uno SR 2013 from FSA K-force Light BB386 EVO to Campag Record Ultra Torque.
What adaptors/cups do I need and is it a lot more complicated than installing another K-force?

mfin

http://www.wiggle.co.uk/campagnolo-ultra-torque-bb386-bottom-bracket-cups/

Press them into the frame and fit the ultra torque chainset as per its instructions. Nothing odd at all.

(Put wavy washer that comes with cups on the non drive side half of the axle, push into cup, push drive side half into its cup, pop the bolt in and do it up tight (to stated nm spec or just very tight if you have no torque wrench), then fit the clip that comes with the cups to the drive side cup. Done).

josehernandez

As I thought, however I have heard some say that these don’t fit and you need Wilier specific cups??

josehernandez

mfin wrote:

http://www.wiggle.co.uk/campagnolo-ultra-torque-bb386-bottom-bracket-cups/

Press them into the frame and fit the ultra torque chainset as per its instructions. Nothing odd at all.

(Put wavy washer that comes with cups on the non drive side half of the axle, push into cup, push drive side half into its cup, pop the bolt in and do it up tight (to stated nm spec or just very tight if you have no torque wrench), then fit the clip that comes with the cups to the drive side cup. Done).

Have you heard about needing to use Wilier specific cups and do you need to use loctite?

josehernandez

Can anyone else help with this......it seems mfin has exited never to return??

philbar72

if the BB is set to BB386 then all you need are the conversion parts.

Mfin is right. remove the old BB. replace with the items as he has described.