Finish line sealant, anybody used it

2»

Comments

  • steve_sordy
    steve_sordy Posts: 2,453
    Matty2B wrote:
    ............Still no punctures to test it's sealing ability as yet, .............!

    As far as you know!

    On one tyre I had until recently, I had over two dozen punctures and I never knew when I got them, not one!

    I only knew I had them at all was when the bike had been left for a day or so and I could see a slight damp patch where each puncture was. When I was using RRP puncture Guard, it was green and left a green dot at the puncture site; much easier to see.
  • I'm currently using Orange seal, just the normal one not endurance, Running a maxxis minion dhf up front which is tubeless ready, on the back is a maxxis ardent but it is not tubeless ready.

    Been 6 months since converting to tubeless and up untill about two weeks ago both tyres held air extremely well, and only the rear started to lose pressure a bit quicker than normal. I just topped up the sealant in the rear and 2 days later it is still holding 40 psi, which will obviously be dropped when i go for a ride later.

    Can't ever see me wanting to change to anything else after using Orange.