Cheap single clamp grips?

CharlieV453

Hi, recently I have been running a 740mm bar and felt it was quite small so ran the grips out a little over the edge. I think 1cm is ok but I pushed it and snapped the edge of the grip.
Does anyone have any standard pattern grips that they could recommend? I previously used the burgtec bartenders but felt for that they are they were quite expensive when you can get something like the DMR deathgrips for £11. Something cheaper with the regular square pattern would be ideal. I have had a look online and was trying to find some unbranded ones or a cheaper pair as I have just bought a 800mm nukeproof bar but failed to find any.

Any help would be much appreciated.
Thanks

mattyfez

I really reate these: http://www.mbr.co.uk/reviews/products/santa-cruz-palmdale-review

Can be had for £15 if you shop around.

slc123

I've just fitted the nukeproof endurance grips on my new bike build. So far they look pretty good and fairly inexpensive.

Half price on CRC - http://www.chainreactioncycles.com/nuke ... prod158770

CharlieV453

The nukeproofs look good but aren't really what I'm looking for. The santa Cruz look great but may be a bit expensive. If they wear well I may be able justify it.

tothetrail.tv

Absolutely brilliant grips and at £20, a steal. http://amzn.to/2smiQJl

cooldad

Not quite single clamp though.

These are really good

http://www.chainreactioncycles.com/race ... prod106659

CharlieV453

Thanks very much. The race Face look great!

02gf74

How cheap?
. £1.87, eBay item 253323666620

I've used this type without issues but they are quite firm. There are similar one but with a foam grip.

Also the max overlap I have is about 3mm, I think once the grips extend beyond the alloy clamp, the ends are supported by the plastic inside so are likely to snap, 1 cm is too much. Plus the outer clamp does nothing.

CharlieV453

Mine were single clamp so I didn't need to worry about that. 1cm was ok but I pushed it further till it snapped.