Canyon Disc on turbo

deano802
deano802 Posts: 67
edited October 2018 in Indoor training and turbo forum
Has anyone put a canyon disc bike on a turbo? I know canyon say you shouldn't.

I have the thru axle adapter for my elite rampa turbo but it looks to me like the only way to do it is take off the small plate over the rear axle drive side where the screw for the derailleur hanger is then you have the adapters washer pressing against the carbon frame.

Comments

  • cookeeemonster
    cookeeemonster Posts: 1,991
    BUMP!!!

    I have the same question after having a look tonight, though mine is for a tacx vortex
  • deano802
    deano802 Posts: 67
    CookeeeMonster wrote:
    BUMP!!!

    I have the same question after having a look tonight, though mine is for a tacx vortex

    I use mine a few times a week on the trainer exactly as above.
  • cookeeemonster
    cookeeemonster Posts: 1,991
    Deano802 wrote:
    CookeeeMonster wrote:
    BUMP!!!

    I have the same question after having a look tonight, though mine is for a tacx vortex

    I use mine a few times a week on the trainer exactly as above.

    Ah cheers I just wanted a bit of reassurance it all works ok. The plastic plate seems to be glued on - I assume it just pops off if you push it from the inside?
  • deano802
    deano802 Posts: 67
    CookeeeMonster wrote:
    Deano802 wrote:
    CookeeeMonster wrote:
    BUMP!!!

    I have the same question after having a look tonight, though mine is for a tacx vortex

    I use mine a few times a week on the trainer exactly as above.

    Ah cheers I just wanted a bit of reassurance it all works ok. The plastic plate seems to be glued on - I assume it just pops off if you push it from the inside?

    Correct, easily sticks back on also.

Categories