BT-DN110 Di2 Fitment
pippi_langsamer-2
Posts: 1,470
Sooo....I have Pro Vibe bar and stem, and am looking to install my battery in the steerer tube rather than seatpost and route to a bar end junction box.
Trying to find the best solution to house the battery in the steerer. I believe there's a dedicated expander that can hold the battery and allow preload and etube routing?
Is there another solution? Worried if i used the rubber seatpost "bung", and shoved the battery right down the tube, I might not get it back when needed! It would have to go right down to enable the normal expander to fit. That's also assuming the end of the etube will pass thru the standard compression device...
Trying to find the best solution to house the battery in the steerer. I believe there's a dedicated expander that can hold the battery and allow preload and etube routing?
Is there another solution? Worried if i used the rubber seatpost "bung", and shoved the battery right down the tube, I might not get it back when needed! It would have to go right down to enable the normal expander to fit. That's also assuming the end of the etube will pass thru the standard compression device...
0
