Tightening name plate screw

rower2cyclist
rower2cyclist Posts: 14
edited August 2017 in Workshop
Hi-I have a Ultegra hydraulic disc groupset. How do I tighten the tiny fixing screw on top of the name plate? What kind of screwdriver should I use? I can't get a good angle even when I squeeze the lever. Thank you

http://bike.shimano.com/content/sac-bik ... rs685.html

http://si.shimano.com/#/en/EV/ST-RS685-3675

Comments

  • redvee
    redvee Posts: 11,922
    One way of getting more lever travel is to shift the lever so the chain is on the largest sprocket, assuming it's LH/Rear, then downshift but don't turn the crank so that you have plenty of cable slack. Now move the lever as you would when shifting but hold it and squeeze the lever as if braking and it'll move a little bit more hopefully.
    I've added a signature to prove it is still possible.
  • rower2cyclist
    rower2cyclist Posts: 14
    This is helpful, thanks so much!

Categories