5mm Conical Headset spacer/headset cover

JesseD
JesseD Posts: 1,961
edited March 2017 in Road buying advice
I am looking to lower my stem by 5mm and at present I have a 10mm Kuota branded conical headset spacer/cover under the stem, I have searched but cannot seem to find a plain carbon one in 5mm anywhere?

Anyone know where I can order one?
Obsessed is a word used by the lazy to describe the dedicated!

Comments

  • bristolpete
    bristolpete Posts: 2,255
    Is the bearing size like this ?

    https://www.westbrookcycles.co.uk/canno ... mm-p265941
  • JesseD
    JesseD Posts: 1,961
    Actually measured height last night and it was 15mm (thought the front was a tad high!!) not 10mm so 5 would have been too low, however it also acts as the dust cover for the top bearing and is specific to the headset apparently so ended up going back to my LBS where I bought the bike and ordering one in.

    Thanks for looking though Bristolpete
    Obsessed is a word used by the lazy to describe the dedicated!

Categories