Ribble R872 DI2 Install problems

revilo88

Hi all,

I recently bought an upgrade kit for my R872, Im having a few problems with wire routing at the minute.

I have taken off the cranks and bearings etc. I just seem to be left with a shell that looks like its been possibly press fitted?
I have attached a photo to show what i mean.
https://www.dropbox.com/s/c3bkjorx030nijr/20151231_192356.jpg?dl=0

My question is is how easy would it to be remove and how? would this of been bonded in? Or am i going to have to work out another way to run my wires?

Any info would be greatly appreciated.

Kind Regards,

Olly

meanredspider

I'm guessing thus us just a press-fit BB shell. If you can get a tool on it, it should press or tap out with a drift. It'll be tough to run the Di2 wires without removing it. If you aren't confident, take it to your LBS and get them to remove it.