Tools required to grease bb bearings?
Hello everyone,
I am curious about the tools required to grease the bottom bracket bearings on my cervelo R3 with the bbright and FSA grossmer crank. It looks like I just need to take the crank off and then just use a small flat end screwdriver or knife to pull the seal off and lubricrate. Is that the case?
Thanks!
I am curious about the tools required to grease the bottom bracket bearings on my cervelo R3 with the bbright and FSA grossmer crank. It looks like I just need to take the crank off and then just use a small flat end screwdriver or knife to pull the seal off and lubricrate. Is that the case?
Thanks!
0
Comments
-
Or do I need to purchase these tools too?
http://www.amazon.ca/FSA-Bearing-Removal-Consumer-Grade/dp/B0027BJSFI/ref=pd_bxgy_200_img_2?ie=UTF8&refRID=0RQQX0BJSXGH0FNX57KB0 -
if you can expose the bearings then you can grease them without removing from the bb, although if they're dirty it'll be harder to clean them in place
a cheap plastic syringe is good for getting the grease in
to remove seals i use a fine pick, less chance of damaging the seal, be careful as they are easy to bendmy bike - faster than god's and twice as shiny0
