Cube suspension advice
mightyi
Posts: 73
Hi All!
I'm just buildin up a new full bike using a second user Cub Stereo 2011 Frame - howerver i can't find any clear details abou the torque settings and any specific servicing procedure for this frames' pivot point mountings. I've contacted cube twice now and not even had a courtesy email from them, so am clutching at straws now! There are some settings on their site but they are quite abiguous with regards to a 2011 model - one set states 2008> and one states 2010-2011!
Can anyone assist please?
Cheers!
I'm just buildin up a new full bike using a second user Cub Stereo 2011 Frame - howerver i can't find any clear details abou the torque settings and any specific servicing procedure for this frames' pivot point mountings. I've contacted cube twice now and not even had a courtesy email from them, so am clutching at straws now! There are some settings on their site but they are quite abiguous with regards to a 2011 model - one set states 2008> and one states 2010-2011!
Can anyone assist please?
Cheers!
0
Comments
-
There won't be any service procedures for a frame. The bearings are sealed for life and non serviceable. Just clean and grease pivot bolts occasionally, don't over grease as that will attract dirt and turn to a grinding paste.
I would just use the torque settings manual on the Cube website.The 2011 model was the same as the 2010 but that document was published in 2010 so doesn't mention it. Make sure you thread lock the pivot bolts.Transition Patrol - viewtopic.php?f=10017&t=130702350
