Converting 130 hub to 135

coinneach
coinneach Posts: 79
edited June 2015 in Workshop
I have a miche racing rear hub with is 130 wide.
I'd like to convert it to 135, I'm not bothered about dish etc, but can a simple spacer be used, or does one have to rebuild the hub?
Thanks
"It is good to have an end to journey toward, but it is the journey that matters in the end."

Comments

  • keef66
    keef66 Posts: 13,123
    Simple maths would suggest a 2.5mm spacer each side would do the job and keep the wheel centered between the dropouts. But then your axle would be 5mm too short. If you can find a 5mm longer axle you'll be sorted (I'm assuming it's a QR type hollow axle here)
  • ugo.santalucia
    ugo.santalucia Posts: 28,312
    It's not a threaded axle, is it? You can only respace threaded axles
    left the forum March 2023
  • cycleclinic
    cycleclinic Posts: 6,865
    The parts dont exist to do the job.
    http://www.thecycleclinic.co.uk -wheel building and other stuff.