Duraace cranks hollow tech 2 into SRAM pressfit 30?
stevienicknacks
Posts: 35
I have the chance if a new set if Duraace cranks at a good price. The cranks are hollow tech 2 BB. Is there a way to make them fit into my Scott CR1 which has an SRAM press fit 30 BB currently. Thanks
0
Comments
-
0
-
They are for Sram GXP cranks so won't work.
The Wheels Manufacturing BB30 to Shimano 24mm spindle adapters should work.
http://www.wiggle.co.uk/wheels-manufact ... dle-shims/
or these for £9.99
http://www.planetx.co.uk/i/q/BBFSAPF30R ... -aluminium0 -
Thanks TF0
-
Or you could remove the current BB and get the Shimano press fit BB that fits your frame.
My CR1 came with one already installed, which has been handy since I've been swapping HT2 chainsets quite frequently.0 -
keef66 wrote:Or you could remove the current BB and get the Shimano press fit BB that fits your frame.
My CR1 came with one already installed, which has been handy since I've been swapping HT2 chainsets quite frequently.
Shimano won't have anything to do with 30mm spindle cranks - your frame is BB86, different press-fit standard.Make mine an Italian, with Campagnolo on the side..0 -
Crikey; didn't realise Scott had done the CR1 with so many different BB options!0
-
Thanks chaps, I've gone with the adaptor option I'll let you know how I get on.0
-
Are you sure that the bb is a bb30 and not a sram gxp bb86 like this
http://www.chainreactioncycles.com/ie/e ... -prod75586
I have built up quite a few cr1 frames and they all were bb86 or BSA threaded haven't seen a bb30 one. I think you will only need one of these.
http://www.chainreactioncycles.com/ie/e ... -prod618030 -
Just went to fit the adaptor and the cups are too big.0
-
How much of a difference in size is there ?0
-
Quite a lot, im going to have another good look tomorrow with the chainset back off.0
-
Think I'm going mad... Just had another look There was a cover over the outer shell, it's a BB86 by the look of it. Think I'll just put a new BB in as clogg suggested.0
-
stevienicknacks wrote:Think I'm going mad... Just had another look There was a cover over the outer shell, it's a BB86 by the look of it. Think I'll just put a new BB in as clogg suggested.
Or as I suggested a week before that
0
