Hope Mono RS measurements

brettjmcc

Probably most likely a question for Ugo, but if anyone can help

Does anyone have the measurements for front and rear Mono RS hubs please? I am planning to order some, but just want to have a play around with different rims and configuration on the DT Swiss Calculator. Thanks

ugo.santalucia

Can't remember... but I use the old measurements for the PRO 3 which you can find with the following corrections

Front hole circle is 40.5 instead of the older 38
Rear drive side is 56 instead of 54 and non drive side is 46 instead of 45... the flange spacing is pretty much the same... or not enough to make a difference

brettjmcc

Thanks Ugo,

Does this look right for a Mono RS/Belgium+ build? The € price means it is tempting to add spokes to my order from Germany at the moment, but I won't have access to the rims until early April

MonoRS_Belgium by Brett-GT40, on Flickr

ugo.santalucia

I said 40.5 not 42

The rear is fine... the front might need 1 extra mm

brettjmcc

Apologies I was doing it in work... and had multiple windows open... I'm also having to take the assumption the ERD is correct at 592 for the Belgium+

You are correct that it needs another mm. If i can order in even increments, shoudl I go 276 for the front and 282 on the NDS? Thanks

MonoRS_Belgiumv2 by Brett-GT40, on Flickr

ugo.santalucia

No. Go 284 for the rear and 276 for the front