overshifting between 5th-1st cogs
Evening all
I seem to have developed a problem with my rear derailleur (Campy Athena)... when shifting up/out from round about the 5th or 4th smallest cog, the chain jumps at least one or two cogs. I thought the cable might be too loose but it is absolutely fine shifting in the opposite direction and even if I tighten the barrel adjuster far enough to hear the chain rattle on a bigger cog, I still have the same problem shifting up/out.
I wondered if it might be time to replace the cassette as it's done almost 6000km. I doubt it's the chain as this was replaced fairly recently.
Any suggestions would be much appreciated, thanks.
I seem to have developed a problem with my rear derailleur (Campy Athena)... when shifting up/out from round about the 5th or 4th smallest cog, the chain jumps at least one or two cogs. I thought the cable might be too loose but it is absolutely fine shifting in the opposite direction and even if I tighten the barrel adjuster far enough to hear the chain rattle on a bigger cog, I still have the same problem shifting up/out.
I wondered if it might be time to replace the cassette as it's done almost 6000km. I doubt it's the chain as this was replaced fairly recently.
Any suggestions would be much appreciated, thanks.
0
Comments
-
If you have replaced the chain recently but not the cassette then that is the answer esp after that mileage0
