Ultra Torque bearing puller

gaddster
gaddster Posts: 401
edited July 2014 in Workshop
Looking to remove & replace the bearings on my UT cranks and found this puller, here

Any reason why this wouldn't work? It looks like the jaws are thin enough and is deep enough too. The UT bearings are 37mm OD and this is for 30-90mm widths.

Can't see why it wouldn't work and is a nice saving over the park one.

Thanks
ARTHUR
"Hello oh great one"
LARRY
"Are you talking to me or my ass?"

Comments

  • Monty Dog
    Monty Dog Posts: 20,614
    Looks fine to me. Just need the right size piece of tube to fit the bearing.
    Make mine an Italian, with Campagnolo on the side..
  • gaddster
    gaddster Posts: 401
    Thanks for that Monty Dog, am I right that the drift need to contact the inner race of the bearings when fitting? So something about 25mm in diameter

    Thanks
    ARTHUR
    "Hello oh great one"
    LARRY
    "Are you talking to me or my ass?"
  • Monty Dog
    Monty Dog Posts: 20,614
    Yup, 25mm ID should be fine, even better if it only presses against the inner part of the bearing race too.
    Make mine an Italian, with Campagnolo on the side..
  • on-yer-bike
    on-yer-bike Posts: 2,974
    Can you let us know if this puller works on your UT bearing? Thanks.
    Pegoretti
    Colnago
    Cervelo
    Campagnolo

Categories