Hope pro 3 mono rear

peterwilliams
peterwilliams Posts: 6
edited May 2014 in Workshop
Hi,

I've got the hope pro 3 mono rear hub. I was looking to get the tools to service it before building the wheel (don't want to spend all this money on the hub and have it wrecked!). Is there any where I can get these tools; the only tools I have seen have been for the pro 2 hub, are they the same?

Thanks very much. :mrgreen:

Comments

  • styxd
    styxd Posts: 3,234
    No tools required.

    Just use a socket piece to hammer the bearings in with if you need to.

Categories