h plus sons plus durace 9000 spoke lengths

gwillis
gwillis Posts: 998
edited March 2014 in Workshop
Anybody check my figures on the following i can't find any data on dura ace 9000 front hubs so do they differ in spec to earlier ones 7800/7900?

Front 28 hole 2 cross dura ace 9000 hubs 28 hole

rear 32 hole 3 cross dura ace 9000 hub

non drive side 290

drive side 289

cheers

Comments

  • cycleclinic
    cycleclinic Posts: 6,865
    I know the lengths for DA 7700 hubs which are the same as 7800 and so similar to 9000 are 290 front and 288mm DS 289mm NDS. Well that what I would use. You can go 1mm longer on the rear if you like never tried to know if it works. I use an ERD of 593mm for the archetype at least that what I measure them at. ERD of 595 always means I have to round down by over a 1mm to not run out of spoke thread.
    http://www.thecycleclinic.co.uk -wheel building and other stuff.
  • gwillis
    gwillis Posts: 998
    Thanks Malcom much appreciated. A tad different to what i had :oops:
  • cycleclinic
    cycleclinic Posts: 6,865
    I can't see the messages you have sent. You will have to post here or e-mail me.
    http://www.thecycleclinic.co.uk -wheel building and other stuff.
  • ugo.santalucia
    ugo.santalucia Posts: 28,312
    PM system is down at the moment
    left the forum March 2023
  • gwillis
    gwillis Posts: 998
    No probe it was only a thank you …. I would have hassled you Paolo but any more messages to you and I see and injunction coming my way