A different type of V Brake "Noodle"
gt-arrowhead
Posts: 2,507
Ive just seen one of these, were wondering how these would make a difference.
0
Comments
-
Bit neater. Unless there's a roller in there, then more spring return will be needed.
Bit like what I used to have on my mech to cut the loop by 90 degrees0 -
I remember those mech devices.
Apparently they are machined out of a single piece of aluminum, so im assuming theres nothing else in there. I forgot to add the link. http://www.ebay.co.uk/itm/Retro-CNC-Alu ... 51b4326414
Ive also seen these, http://www.ebay.co.uk/itm/RED-Flexible- ... 43bf961745 Is fully flexy a good idea?0 -
I use the flex ones, work fine, better cable entry too.0
-
Cheers. I might go for those flexy ones.0
