Seat post settings!
Comments
-
12nm is the torque setting as suggested by Scott0
-
Thanks but where did you find that out?0
-
Hi,
I am going to be starting a build for a Scott foil, did you find a manual, I have looked online and can not seem to find one.
Also did you go to 12nm torque for the seat post??0 -
Hi Matty,
No, I didn't find a manual but I did go to my local bike shop and found out that the tolerance is between 10 and 12nm.
My advice is no more than 10nm unless absolutely necessary!
Your hearts in you mouth tightening a carbon seatpost that tight.
Good luck,
Dean0 -
I'd be using some carbon paste and doing it up only as tight as required to stop it slipping.0