Specialized push fit BB nightmare
tomstickland
Posts: 402
2012 Stump Jumper comp with BB30 push fit bearings on a SRAM 2 x 10 setup.
Bearings went wobbly after 6 months of rain and grit.
Local bike shop have been trying to source the parts from Fisher since November - on back order until late Feb now.
I'm going to leave them trying that. Meanwhile, is there a viable solution for a conversion kit so I have threaded bb adapters pushed in?
Bike spec: http://www.specializedconceptstore.co.uk/detail/12sjfsr/stumpjumper%20fsr/stumpjumper%20fsr%20comp/
Bearings went wobbly after 6 months of rain and grit.
Local bike shop have been trying to source the parts from Fisher since November - on back order until late Feb now.
I'm going to leave them trying that. Meanwhile, is there a viable solution for a conversion kit so I have threaded bb adapters pushed in?
Bike spec: http://www.specializedconceptstore.co.uk/detail/12sjfsr/stumpjumper%20fsr/stumpjumper%20fsr%20comp/
0
Comments
-
-
all they are are bearings take the old ones to a bearing shop.
or http://www.google.co.uk/search?q=bb30+b ... 20&bih=950
and maybe look at the Kcnc converter bb for a HT2 crank"Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
Yes, exactly like that.
The bearings will not come out of the push fit housing without damaging it - I've tried that angle already.0 -
Two bike shops and me are confused now.
Spec says SRAM PF30.
Websites show BB30 adaptors. Not clear if these will fit.
I'm going to pick the bike up and take it apart.0 -
this should help,
I may be wrong but pretty sure Specialized do not use BB30.
http://service.specialized.com/collater ... racket.pdf0 -
