Truvativ Hussefelt

a2hgo
a2hgo Posts: 56
edited November 2012 in MTB workshop & tech
I was after a new 36T chainring for my Kona Stinky that came with this crankset from the factory.

I thought it was a standard 104 BCD so bought this from CRC:

http://www.chainreactioncycles.com/Mode ... tAodCHMAzg

I've gone to fit it today and it won't fit... :(

Any ideas what size I need? It fits on the outside of the prongs on the crank but that causes it to sit too far out for my chain device, it needs to sit on the inside like the current ring.

Comments

  • nicklouse
    nicklouse Posts: 50,673
    it is.
    how does it not fit.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • The Rookie
    The Rookie Posts: 27,812
    Some 104BCD middle rings have a different bore location size, a file will sort it out, file down the location tabs until its fits.
    Currently riding a Whyte T130C, X0 drivetrain, Magura Trail brakes converted to mixed wheel size (homebuilt wheels) with 140mm Fox 34 Rhythm and RP23 suspension. 12.2Kg.
  • a2hgo
    a2hgo Posts: 56
    Its like the tabs on the inside are stepped in a little compared to the outside, are you saying just file the new chain ring down?

    Photo24-11-2012170219.jpg

    Photo24-11-2012170253.jpg
  • nicklouse
    nicklouse Posts: 50,673
    yes.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown

Categories