Poploc adjust circlip?
angry_bird
Posts: 3,787
Am I right in thinking there should be a circlip or something to hold the blue compression dial in on a RS poploc adjust lever, so as it doesn't just unscrew?
Can't seem to find one in mine (it's not been working recently- my fault, adjusting it when it wasn't locked out), but I was very careful when I took it apart as I was expecting a loose one to fall out, I mean I'm 99% sure ine hasn't fallen out so I can only assume it's snapped and managed to fall out at some point when I've been riding.
Basically anyone know what size etc. a replacement needs to be or how I'd go about measuring to find the right size. I've tried to the RS website but they don't seem to have any tech docs for the levers.
Can't seem to find one in mine (it's not been working recently- my fault, adjusting it when it wasn't locked out), but I was very careful when I took it apart as I was expecting a loose one to fall out, I mean I'm 99% sure ine hasn't fallen out so I can only assume it's snapped and managed to fall out at some point when I've been riding.
Basically anyone know what size etc. a replacement needs to be or how I'd go about measuring to find the right size. I've tried to the RS website but they don't seem to have any tech docs for the levers.
0
Comments
-
Mine had a circlip. I lost mine too. I just took the forks into a local motor factors and had a look through the little trays of circlips they had until I found one that fitted. Should only cost you a few pence.0
-
Cheers, will look into it tomorrow then0
