Fox 36 Float Side Question

sam2391
sam2391 Posts: 10
edited June 2012 in MTB workshop & tech
Ok so I removed the lowers and oil came out the FIT side but hardly any from the float side (air side). (I put 30mls in each leg last time I did a lower leg service) I then removed the top cap on the air side and pushed the rod up from the bottom and used a syringe to remove the oil from the top, inside the stantion and there was around 25-30ml in there of mostly green colored 10wt. I thought there was only supposed to be 5ml of float fluid there? If that's the case how did it end up above the piston?

Comments

  • bennett_346
    bennett_346 Posts: 5,029
    Dunno. I'd just drain all the oils and put them back with the right amounts. Doesn't sound like a problem unless they feel wrong riding them.
  • getonyourbike
    getonyourbike Posts: 2,648
    Dead seals. Buy the kit and get them changed

Categories