Fox RP2 ProPedal problems

streetvw
streetvw Posts: 164
edited April 2012 in MTB workshop & tech
OK guys

rescently replaced the seals and oil in my RP2 boost valve shock and since then the ProPedal doesn't seem to be working properly anyone got any ideas what could be causing this and any potential fixes
cheers
Dave
2011 Canyon Nerve XC7 viewtopic.php?t=12765275

Comments

  • bennett_346
    bennett_346 Posts: 5,029
    More detail of how it isn't working needed.
  • 1mancity2
    1mancity2 Posts: 2,355
    bennett_346 wrote:
    More detail of how it isn't working needed.

    +1 and what oil or do you mean float fluid? and how much did you use?
    Finished, Check out my custom Giant Reign 2010
    Dirt Jumper Dmr Sidekick2
  • cloudynights
    cloudynights Posts: 351
    you may have to send it away to get the damper unit serviced, only problem with fox shocks :( i had a similar thing so decided to bite the bullet and change to rockshox, just done first full service on it including damper seals and oil change
    was of the bike and back on within 40 mins
    anthem x with many upgrades
  • streetvw
    streetvw Posts: 164
    thanks for the reply's

    the shock seems to be moving more than it was before.

    I'm not entirley sure that me rebuilding it has caused the problem or if it was something to do with it loosing pressure which propted me to redo the seals.

    yes I did mean float fluid I used the amount as shown in the rebuild instruction on youtube http://youtu.be/vb8BNsFcINQ
    2011 Canyon Nerve XC7 viewtopic.php?t=12765275

Categories