RS Boxxer with Maxle DH
dirty face
Posts: 139
Quick question, when I remove / replace the front wheel on my Session, the mannual says to turn the non-drive side until 'no clicks are heard', then remove the maxle. When replacing, screw in the maxle, then turn the non-drive side '8 clicks'
however, there are far more available 'clicks' than just eight, and if i keep turning it (adding more clicks) it then eventually tightens. So is 8 clicks enough to secure it? and will i do damage if i turn it even more clicks until it tightens?
however, there are far more available 'clicks' than just eight, and if i keep turning it (adding more clicks) it then eventually tightens. So is 8 clicks enough to secure it? and will i do damage if i turn it even more clicks until it tightens?
If you don't fall off you're not trying hard enough!
0
