Giant VT-2 linkage plays

Dirtrider

Alrite Dudes,

I have a problem with my VT, I'm not sure if you are aware of the linkage system, but the linkage which goes through the bottom part of the shock has some play in it.

Basically, the bolt that goes through the hole, has a bearing which it moves on. However, there is a bit of play. This is because there is a slight gap between the hole in the shock, and the rod thing that goes through it.



You can see on the picture, (the shock is upside down the picture) but its the bottom of the shock.

Any suggestions or knowledge on how to fix it?

Thanks.

nicklouse

worn DU bush?

replace it and the bolt at the same time.

Dirtrider

Hmmmm, good point.

It's very frustrating for me, I used to work as a bike mechanic but have been out of it for a few years. Where would you get a DU bush from?

cooldad

BETD, TF Tuned, bike shop.

Dirtrider

Thanks, just ordered one from TF Tuned.

Ideally, I would like to get the whole bearing kit, its just not worth it as am looking at replacing the frame soon.