slow return on manitou revox rear shock

Davy-g
Davy-g Posts: 401
edited December 2011 in MTB workshop & tech
I have just finished rebuilding my 2008 Trek Session 10 after changing all frame/pivot bearings...I have Tested rear triangle and it moved up and down clean and sweet..
I then Installed the Manitou Revox shock and then tested that by pushing down on the seat, shock compressed OK but didn't return back to the start position, instead it very,very slowly returned.

Shock has been off the bike for about 2 weeks.... and nothing had been changed or played about with on the shock (that I am aware off)

can anyone shed any light on the problem... or is this a TF Tuned job. :cry::cry::cry:

Comments

  • nicklouse
    nicklouse Posts: 50,675
    coil or air?

    set the sag?

    you do need to go back through the setting to check.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • Davy-g
    Davy-g Posts: 401
    sorry Nick..it's a coil shock... gonna have another shufty at the manual...
  • Davy-g
    Davy-g Posts: 401
    sorted... it was the rebound adjuster, it was set too slow.... re-adjusted it and all is fine now.... :oops: :oops:

Categories