Turbo Trainer Question

Dirk1978
Dirk1978 Posts: 148
edited October 2011 in Road beginners
I have just purchased my first turbo trainer, an Elite Crono Fluid ElastoGel Trainer. I have put it together and used it a number of times. My question is, the part at the rear that rubs against my tyre is slightly loose and slides from side to side a little as I can't completely fasten the bolts that connect it to the frame of the trainer. Is this correct or should it stay in position?

Cheers

Comments

  • I bought one a while back and it doesnt move - there are three bold positions - try one of the others - it should be solid
  • Muffintop
    Muffintop Posts: 296
    I have the same model. The back section shouldn't move. The unit itself should be a really solid bit of kit. Try undoing the bolts again and then putting them back on.
    FCN: Brompton: 12, Tourer: 7, Racer: 4

    http://www.60milestonod.blogspot.com