Mudguards on a Cannondale?

dartmoorscottydog
dartmoorscottydog Posts: 72
edited October 2011 in Road buying advice
Has anyone tried to put mudguards on a Cannondale Supersix? If so, which guards and were they a b**ger to fit? Thanks

Comments

  • Crud Racers MkII, perhaps. If you're anywhere near Newton Abbot PM me and you can try mine before you buy a set of your own. They just about fit on my Spesh Secteur fitted with 25mm tyres. I would imagine they would fit OK with 23mm tyres.
  • BBH
    BBH Posts: 476
    MKII will fit on a caad10, I see no probs with a supersix.
    Easy to fit.
    2012 Scott Foil 10 (Shimano dura ace) - in progress
    2011 Cervelo S2 (SRAM Red/Force)
    2011 Cannondale Caad 10 (Shimano 105)

    "Hills Hurt, Couches Kill!!"
    Twitter: @MadRoadie
  • thanks for the advice I'll try the Mk II cruds - unfortunately I'm not near Newton Abbott but appreciate the offer from you PP.
  • porker33
    porker33 Posts: 636
    Quite a few of us run crud 2's on caad10's.....they take 20-30 mins to fit and set up, I doubt you could get away with anything wider then a 23mm tyre though.
  • Mike67
    Mike67 Posts: 585
    I managed to get 25s (Conti Gatorskins) on my CAAD9 fitted with Crud Mk1s last Winter.

    It was a very very tight fit though and any little bit of grit would screeeetch away when it got caught underneath...never did manage to ignore that noise.

    I'm running 23s this year :D
    Mike B

    Cannondale CAAD9
    Kinesis Pro 5 cross bike
    Lots of bits