Fulcrum red metal 5 - centre lock adapter

nels
nels Posts: 250
edited August 2011 in MTB workshop & tech
Hi.


wanting to adapt my Fulcrum Red metal 5 centre locks to use 6 bolt. I understand KCNC etc do adapters.. but unsure as to the size required 12T or 20T... or may be someting else completely.

all advise welcomed.
nels
Nels

Trek Fuel EX9
Giant Defy1
Rockhopper SL Expert

Comments

  • supersonic
    supersonic Posts: 82,708
    I guess this is the difference between the standard and oversize centerlock hubs, ie ones that take a cassette tool or HT2 BB tool. I m pretty sure the Fulcrum 5 is the former, smaller standard.
  • nicklouse
    nicklouse Posts: 50,673
    12T tool design for standard QR axles

    FR model uses a 20T tool design for oversize 15mm QR axles
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • kja
    kja Posts: 259
    I have a set of these wheels, they use a large outer locking ring which requires an HT2 BB tool to tighten/remove (or a pair of mole grips!). I seem to remember a post on here where a guy found that the lock rings fouled the adaptor bolts. You're best bet might be to get some centrelock rotors; 160mm for a fiver and 180mm for £12 from on-one http://www.on-one.co.uk/c/q/braking