Rear QR is slightly bent...
thepha5e
Posts: 118
...should i get a new one?
When i put it on a flat surface, at the most, one end is about 1mm off the table, and when i put it in the hub, if you rotate it at one end, you can see it go from side to side a few mm at the other end - so it's very slightly, and i only use the bike for light xc.
So is it worth replacing?
When i put it on a flat surface, at the most, one end is about 1mm off the table, and when i put it in the hub, if you rotate it at one end, you can see it go from side to side a few mm at the other end - so it's very slightly, and i only use the bike for light xc.
So is it worth replacing?
Hardcore hardtail:
viewtopic.php?f=10017&t=12830105
And a single speed commuter bike:
viewtopic.php?t=12787405
viewtopic.php?f=10017&t=12830105
And a single speed commuter bike:
viewtopic.php?t=12787405
0
Comments
-
sounds normal. just use it."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
Ok thanks, just wanted to have piece of mind that it's not going to get metal fatigue and snap
I guess when the qr's tightened there isn't much force on it reallyHardcore hardtail:
viewtopic.php?f=10017&t=12830105
And a single speed commuter bike:
viewtopic.php?t=127874050
