Shimano Tourney Rear Derailler TX50

andy4974
andy4974 Posts: 3
edited June 2011 in MTB workshop & tech
Can someone please help,

The Rear derailler is very tight, with cable unattched from derailler cable runs smooth, the gear change on handle bars is fine. Once attached to derailler its to tight to move with gear change, can be done by hand moving derailler

I have tried everything that i can think of, there is no rust or dirt, everything is oiled nice.

:x :x :x

Comments

  • nicklouse
    nicklouse Posts: 50,675
    so everything moves fin until you connect the wire?

    they I would say you are not attaching the wire correctly or you have a routing issue.
    "Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
    Parktools :?:SheldonBrown
  • andy4974
    andy4974 Posts: 3
    thanks for your quick reply,

    have connected the cable in the same way as when new. will try and change routing, could it be a problem with the cable??

Categories