Hope pro 2 rear hub "Clicking" + axel conv.
BigStu2
Posts: 794
Hi, I'm sure my rear hub is clicking or clacking (softly) when pedaling along, does it need a service, grease ect, fortunatley I've bought all the hope tools to do the job.
As a side note has any one else tried to swap axel conversions between pro 2 and pro 2 evo hubs.
I have a set of pro 2 Evo qr wheels and a set with Pro 2 , 15mm front and maxel rear, I was going to swap them from bike to bike but the front Evo qr axel conv. falls (loosley) into the Pro 2 hub and the Pro 2 15mm axel conv. would need to be pressed into place in the Evo hub at a great risk of not coming out again, haven't tried the rear wheels as yet, any thoughts.
As a side note has any one else tried to swap axel conversions between pro 2 and pro 2 evo hubs.
I have a set of pro 2 Evo qr wheels and a set with Pro 2 , 15mm front and maxel rear, I was going to swap them from bike to bike but the front Evo qr axel conv. falls (loosley) into the Pro 2 hub and the Pro 2 15mm axel conv. would need to be pressed into place in the Evo hub at a great risk of not coming out again, haven't tried the rear wheels as yet, any thoughts.
.........all
...at........work
fun..................&
..no.............no
.....is......play
...at........work
fun..................&
..no.............no
.....is......play
0
Comments
-
TBh as it is a Red day tomorrow call Hope. you may be able to do it with different bearings."Do not follow where the path may lead, Go instead where there is no path, and Leave a Trail."
Parktools :?:SheldonBrown0 -
The rumour is that you can use the Evo rear axle and freehub on the old Pro 2 hub body, but I've never seen it done.Uncompromising extremist0
