Middleburn RS8 X type
monster-mash
Posts: 586
Anyone up on these? Fitted one and followed the instructions where you fit spider lock up the lockring side the non drive-side inc axle in BB fit drive side and tighten bolt finally push drive side so the lockring touches BB bearing and take up slack useing the lcoed coller on non drive side.
Very simplly put in a nutshell my problem is that the arms are not central as in 12mm clearence from the chain stay on non drive side and 6mm on the drive side. Are there any special washers/spacers etc that anyone knows of?
Rgds
Very simplly put in a nutshell my problem is that the arms are not central as in 12mm clearence from the chain stay on non drive side and 6mm on the drive side. Are there any special washers/spacers etc that anyone knows of?
Rgds
0
