RS Rev RLT pop Lock -ve pressure?
ljs1977
Posts: 247
Just got my new bike. Got it initially set up by Sherwood Pines and everything was ace.
Now it has all settled in I have checked the sag on the front and rear and re - set this. Rebound is fine. But not sure about the -ve pressure on the RS.
Is there a rule of thumb or should I just leave it as is if it is not bottoming out?
Cheers
Now it has all settled in I have checked the sag on the front and rear and re - set this. Rebound is fine. But not sure about the -ve pressure on the RS.
Is there a rule of thumb or should I just leave it as is if it is not bottoming out?
Cheers
0
Comments
-
Generally, start off by putting the same amount of pressure in both the positive and negative chambers. Then adjust the negative if it doesnt feel right.0
